Finally the track on the C segment has been fixed in place. Also the Lenz LK200 module was also put to the test and found to be in good working order.This device is necessary since the C(ross) segment actually formes a reverse loop, which raises some problems. The manual actually describes all these best. The track is isolated with Tillig insulating connectors and the wires feeding this segment are only soldered in a single pair of points.
The photo shows the track right after being glued, with locos heavy enough to hold it in place. The bogie visible in the bottom left, belonging to an old PIKO double decker car currently under works, was used to check the radius doesn't drop under the minimum radius value (360 mm).
Niciun comentariu:
Trimiteți un comentariu